OTA Update Component

With the OTA (Over The Air) update component you can upload your firmware binaries to your node without having to use an USB cable for uploads. esphomeyaml natively supports this through its run and upload helper scripts.

Note

Please be aware that ESP8266 modules must be reset after a serial upload before OTA can work. When you are trying to conduct an OTA update and receive an error message Bad Answer: ERR: ERROR[11]: Invalid bootstrapping the reason is very likely that power-cycling the ESP module is required once after the serial upload.

Optionally, you can also define a password to use for OTA updates so that an intruder isn’t able to upload any firmware to the ESP without having hardware access to it. This password is also hashed automatically, so an intruder can’t extract the password from the binary.

esphomelib also supports an “OTA safe mode”. If for some reason your node gets into a boot loop, esphomelib will automatically try to detect this and will go over into a safe mode after 10 unsuccessful boot attempts. In that mode, all components are disabled and only Serial Logging+WiFi+OTA are initialized, so that you can upload a new binary.

# Example configuration entry
ota:
  safe_mode: True
  password: VERYSECURE

Configuration variables:

  • safe_mode (Optional, boolean): Whether to enable safe mode. Defaults to True.
  • password (Optional, string): The password to use for updates.
  • port (Optional, int): The port to use for OTA updates. Defaults to 3232 for the ESP32 and 8266 for the ESP8266.
  • id (Optional, ID): Manually specify the ID used for code generation.

Note

If you get errors like

ERROR [esphomeyaml.espota] Failed
ERROR [esphomeyaml.espota] Host livingroom.local Not Found

when attempting to upload via OTA, please try setting a manual IP for WiFi.